×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Chrysler Cirrus Door Handle
Inside Door Handle- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
34 Door Handles found
Chrysler Cirrus Handle-Front Door Exterior
Part Number: 4696883$37.07 MSRP: $47.18You Save: $10.11 (22%)
| Page 1 of 2 |Next >
1-20 of 34 Results
Chrysler Cirrus Door Handle
The Chrysler Cirrus has Interior Door Handle that enhance the ease of getting into or out of the car. This is about the size of the human's hand and works by unlatching the door by releasing the hook from the latch just like the outside handle. In the course of the usage of Chrysler Cirrus Interior Door Handle, it is subject to wear and tear which may cause the driver's side handle to have scratches thus reducing its general outlook. Besides its intended use, the component intricately connects to the door latch to guarantee appropriate functionality of the locking system. If there is something wrong with the handle or the latch, it creates a lot of problems, particularly to the users. Although the overview does not describe differences in particular styles or types of Interior Door Handle used in different models of Chrysler Cirrus, the continuous emphasis is made on practicality and reliability of designs.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Chrysler Cirrus Door Handle at great affordable prices. Moreover, all genuine Chrysler Cirrus Door Handle come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Chrysler Cirrus Door Handle Parts Questions & Experts Answers
- Q: How to remove and install door latches, handles, and lock cylinders on Chrysler Cirrus?A: This procedure applies to both the front and rear doors. To remove the latch, first take off the door trim panel, ensuring that on vehicles with electric windows, the window is closed before disconnecting the electrical connectors. For manual windows, install the window crank without the retaining clip and roll up the window. If removing a rear door latch, also remove the window glass lower rear run channel. Next, disconnect the lock cylinder, lock button, and latch release operating rods from the door latch. For vehicles with power door locks, disconnect the electrical connector from the door lock motor. Remove the three mounting screws from the end of the door and take out the door latch. For installation, position the latch, install the screws, and tighten them securely. Connect the operating rods to the latch and secure with retaining clips, ensuring not to close the door until the latch is properly adjusted to avoid it not reopening. To adjust, insert a hex-wrench through the elongated hole near the latch, engage it in the socket head screw on the door latch linkage, and loosen it a couple of turns. Lift the outside door handle all the way up and then release it, followed by tightening the socket head screw and checking door operation. For the outside handle removal, take off the door trim panel, close the window on electric window vehicles, and for manual windows, roll up the window with the crank. If equipped with the Vehicle Theft Security System, remove the disarming switch from the door handle, disconnect the operating rod, remove the mounting nuts, and withdraw the handle from the door. Installation is the reverse of removal. For the lock cylinder, first remove the outside door handle, detach the operating rod retaining clip and operating rod from the lock cylinder, and if equipped with the Vehicle Theft Security System, remove the illuminated entry switch wiring clip and disconnect the electrical connector. Use a screwdriver to pry the lock cylinder retainer off and withdraw it from the door, with installation being the reverse of removal.
