×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Chrysler Cirrus Water Pump
H2O Pump- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
4 Water Pumps found
Chrysler Cirrus Water Pump
Water pump is also an essential part of Chrysler Cirrus vehicle, it helps to regulate the engine temperatures through circulation of coolant in the jacket of the engine. This procedure enables the coolant to be able to take in heat produced by the burning of fuel and release it in the radiator. In the past years, most Chrysler Cirrus models implemented belt-driven water pumps, nevertheless, new mechanisms have come up including electric water pumps, which enable a more efficient system by separating the coolant flow rate from the engine speeds. Chrysler Cirrus has over the years witnessed changes on the Water Pump designs especially with regards to the material used ranging from cast iron to aluminum casting. There are also performance oriented water pumps which come with sturdier impellers and improved internal passages to enhance the coolant circulation in performance oriented automobiles and engines. These pumps can be mechanical or electric and electric pumps allows versatile control in installation and therefore more efficient temperature regulation and less parasitic loss.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Chrysler Cirrus Water Pump at great affordable prices. Moreover, all genuine Chrysler Cirrus Water Pump come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Chrysler Cirrus Water Pump Parts Questions & Experts Answers
- Q: How to remove and install a water pump on Chrysler Cirrus?A: Four-cylinder engines, Disconnect the negative battery cable from the ground stud on the left shock tower. Raise the vehicle and securely support it on jackstands. Remove the right inner splash shield. Remove the drive belts. Drain the cooling system. Using a floor jack (with a wood block placed between the jack head and the oil pan to prevent engine damage), support the engine from underneath and remove the right engine mount. Remove the power steering pump bracket bolts and move the power steering pump and bracket aside. The power steering lines do not have to be disconnected. Remove the right engine mount bracket. Remove the timing belt. Remove the inner timing belt cover. Remove the bolts attaching the water pump to the engine block and remove the pump. Install a new O-ring in the water pump body groove. Installation is the reversal of removal. Tighten the mounting bolts. Reinstall the pulleys and drive belts and check for tension. Refill the cooling system. Run the engine and check for leaks. V6 engine: Disconnect the negative battery cable from the ground stud on the left shock tower. Remove the drive belts and drain the cooling system. Remove the crankshaft damper/pulley, timing belt covers, and timing belt. Remove the water pump mounting bolts. Separate the pump from the water inlet pipe and remove the pump. Clean all the gasket and O-ring surfaces on the pump and the water pipe inlet tube. Install a new O-ring on the water inlet pipe. Wet the O-ring with water to facilitate assembly. Install a new gasket on the water pump and install the inlet opening over the water pipe. Press the water pipe into the pump housing. Install the water pump mounting bolts and tighten the bolts. Install the timing belt. The remainder of the installation is the reverse of removal. Refill the cooling system and operate the engine to check for leaks.
Related Chrysler Cirrus Parts
Chrysler Cirrus Radiator
Chrysler Cirrus Thermostat Housing
Chrysler Cirrus Power Steering Pump
Chrysler Cirrus Coolant Temperature Sensor
Chrysler Cirrus Thermostat Gasket
Chrysler Cirrus Water Pump Gasket