×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Chrysler Laser Wiper Motor
Windshield Wiper Motor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
1 Wiper Motor found
Chrysler Laser Wiper Motor
The Wiper Motor in Chrysler Laser automobiles helps to control the wipers for the purpose of wiping rain water and other materials which hinders visibility on the wind screen. This electric motor is designed to have a multiple speed range whereby drivers can control the speed at which the wiper is operating with regards to the prevailing weather conditions. Chrysler Laser Wiper Motors are categorized under new and refurbished production category. New Wiper Motors are purchased from the manufacturers while remanufacturered motors are original motors that have been used before but are now restored to their optimal performing state due to repairs and exchange of parts as may be the case. The existence of these two types makes it possible for Chrysler Laser owners to go for brand new solutions or even refurbished ones at relatively low cost.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Chrysler Laser Wiper Motor at great affordable prices. Moreover, all genuine Chrysler Laser Wiper Motor come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Chrysler Laser Wiper Motor Parts Questions & Experts Answers
- Q: How do you remove and install a iftgate wiper motor on Chrysler Laser?A: As a way of removing the wiper motor, unfasten the negative cable of the battery and allow it to be set aside and well away from the battery negative terminal. Next, pop the liftgate open and unscrew the two trim cover screws; it is possible for one of them to be missing on some car models, but do not worry as that is an ordinary occurrence; after that, remove prying each of the plastic pins and then using a screwdriver to take off the cover. Detach wiper arm by pulling its release tab with the help of a flat screwdriver and disconnect the connector taking out its clip. Subsequently, discard two wiper motor mounting bolts and then pull out the wiper motor with the help of lift gate. Remove the motor from the mounting plate and then switch the plate to the new motor. For installation which should be done carefully for safety purpose, place the motor and fix the bolts well and tightly then connect the wires and make the connector tight. Lastly screw the trim panel back and using your hand drive the retaining pin into the hole and working along the longeron to provide all pins, the last ones the screws from the plastic clips.
