Genuine Chrysler Town & Country Fog Light Bulb

Chrysler Town & Country Fog Light Bulb Parts Questions & Experts Answers

• Bulb
  L0009145
  Q: How do you replace Fog Light Bulb and other bulbs on Chrysler Town & Country?

  A: First for the replacement of the exterior light bulbs take out the front park and turn signal bulb, first by unscrewing the Headlight housing, disconnecting the electrical connectors and then removing the bulb socket by rotating anti clockwise. To replace a bad bulb, carefully twist the bulb and pull it up and out, insert new bulb and repeat the procedure in the reverse order. For front fog light bulbs: lift the vehicle, snap off the electrical connector, turn the socket anti-clockwise to unbolt it, and then replace the bulb/socket assembly and do not touch the bulb surface. For the center high-mounted brake light bulb, first, there will be two or three screws that hold it in place, unscrew it, next you take out the whole assembly and then remove the bulb from it. For tail light bulbs the retaining screws should be withdrawn, then the assembly should be turned in order to unlock it, the electrical connector should be disconnected and finally the bulb socket should be removed by pressing both tabs. Remove the bulb by pulling it directly upwards and the installation is done in the same manner. For license plate light bulbs, the screws which hold it must be undone, and the assembly pulled down so that the bulb can be pulled out of the socket. Starting with the interior light bulbs, the first one is the Instrument Cluster These are removed, rotated anticlockwise and then replaced with a new one by rotating the bulb socket in the clockwise direction. For courtesy lights unscrew the light from the door trim, pull the electrical connector, unscrew the lens and change the bulb. For dome/cargo lights you get to the profile of the light and pry off the lens you thereafter remove the bulb and repeat the process in order to install the bulb. For the glove box light, first, open the glove box then push the switch through the hole then remove the electrical connector more the bulb from the switch. To change the liftgate light bulb, one has to gently pull the lens of the trim panel to be able to remove the bulb and then just do it in reverse. For reading lights using lens, the lens should be removed by twisting it in anti-clockwise direction to unclip the bulb from the reflector while installation is in reverse procedure. Last, to install the vanity lights pry off the lens, remove the bulb and follow the same process in reverse to the process just described above.