How to Replace a Thermostat on Chrysler Town & Country?

Before assuming the thermostat is to blame for a cooling system problem, check the coolant level and temperature gauge operation. If the engine seems slow to warm up, the thermostat might be stuck open and needs replacement. If the engine runs hot and the upper radiator hose isn't hot, the thermostat could be stuck closed and must be replaced. Caution: Don't drive the vehicle without a thermostat as emissions and fuel economy may suffer. If the hose is hot, it indicates the coolant is flowing, and other cooling system diagnosis may be required. To replace the thermostat, disconnect the cable from the negative battery terminal, drain the cooling system, and locate the thermostat housing cover by following the upper radiator hose. Loosen the hose clamp, detach the hose, and remove the housing cover fasteners and cover. Take note of the thermostat and gasket installation, remove material from the staked areas if necessary, and clean all traces of the old gasket from the surfaces. Install the new thermostat with the jiggle pin at the 12 o'clock position, and the spring end directed into the engine. Use RTV sealant if appropriate, and install a new gasket. Reattach the cover, hose, and all previously removed components, reconnect the battery, refill the cooling system, and start the engine to check for leaks and proper thermostat operation.

Genuine Chrysler Town & Country Thermostat

Engine Coolant Thermostat

Select Vehicle by Model
Select Vehicle by VIN

Select Vehicle by Model

Make

Model

Year

Select Vehicle by VIN

For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).

6 Thermostats found

View related parts
Chrysler Town & Country Water Pump
Part Number: 4573560AB
$24.30 MSRP: $35.85
You Save: $11.55 (33%)
ADD TO CART
Product Specifications
- Other Name: THERMOSTAT Water Pump 195 Degrees
- Replaced by: 4573560AE
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1998-2007 Chrysler Town & Country | Base, EL, Limited AWD, Limited FWD, LX AWD, LX FWD, LXi AWD, LXi FWD, SX | 6 Cyl 3.3L, 6 Cyl 3.8L
View related parts
Chrysler Town & Country THRMOSTAT
Part Number: 4666140AA
$37.11 MSRP: $54.55
You Save: $17.44 (32%)
ADD TO CART
Product Specifications
- Other Name: Thermostat
- Replaced by: 68273161AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2007-2010 Chrysler Town & Country | Base, Limited, Limited FWD, LX, LX FWD, Touring, Touring FWD, Touring Plus | 6 Cyl 3.3L, 6 Cyl 3.8L, 6 Cyl 4.0L
View related parts
Chrysler Town & Country Water Pump
Part Number: 4573560AC
$21.22 MSRP: $31.25
You Save: $10.03 (33%)
ADD TO CART
Product Specifications
- Other Name: THERMOSTAT Water Pump 195 Degrees
- Replaced by: 68210217AA
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2001-2006 Chrysler Town & Country | Base, EL, EX, Limited AWD, Limited FWD, LX AWD, LX FWD, LXi AWD, LXi FWD, Touring AWD, Touring FWD | 6 Cyl 3.3L, 6 Cyl 3.8L
View related parts
Chrysler Town & Country THRMOSTAT
Part Number: MD997310
$14.51 MSRP: $18.75
You Save: $4.24 (23%)
ADD TO CART
Product Specifications
- Other Name: THERMOSTAT Package; Thermostat
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1990-2000 Chrysler Town & Country | LX FWD, LX Long Wheelbase FWD, LX Short Wheelbase FWD, LXi FWD, SX | 6 Cyl 3.0L
View related parts
Chrysler Town & Country THRMOSTAT-195 Degrees Purchasing
Part Number: 4494470
$16.57 MSRP: $21.09
You Save: $4.52 (22%)
ADD TO CART
Product Specifications
- Other Name: Thermostat
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 1990-1995 Chrysler Town & Country | Base AWD, Base FWD | 6 Cyl 3.3L
View related parts
Chrysler Town & Country THERMOSTA
Part Number: 68031574AA
Product Specifications
- Other Name: Thermostat
- Warranty: This genuine part is guaranteed by Mopar's factory warranty.
Fits the following Vehicles:
- 2008-2011 Chrysler Town & Country | Limited, LX, Touring, Touring Plus

Chrysler Town & Country Thermostat

The Thermostat in Chrysler Town & Country vehicles is a very important part in the engine cooling system of the automobiles. Sitting adjacent to the radiator, the Chrysler Town & Country Thermostat is a type of closed-loop control that regulates the levels of coolant coming into the body of the vehicle according to the required temperature. For the Chrysler Town & Country models the following thermostats have been used over the years mechanical and they include the bimetallic strip and wax pellet thermostat. These devices work through the mechanism of either expanding or contracting influenced by the temperatures involved thus regulating engine heat. The development of such thermostats has made the Chrysler Town & Country's cooling system efficient and effective to the performance of this automobile and comfort of riders.

Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Chrysler Town & Country Thermostat at great affordable prices. Moreover, all genuine Chrysler Town & Country Thermostat come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.

Chrysler Town & Country Thermostat Parts Questions & Experts Answers

Water Pump
4573560AC
Q: How to Replace a Thermostat on Chrysler Town & Country?
A: Before assuming the thermostat is to blame for a cooling system problem, check the coolant level and temperature gauge operation. If the engine seems slow to warm up, the thermostat might be stuck open and needs replacement. If the engine runs hot and the upper radiator hose isn't hot, the thermostat could be stuck closed and must be replaced. Caution: Don't drive the vehicle without a thermostat as emissions and fuel economy may suffer. If the hose is hot, it indicates the coolant is flowing, and other cooling system diagnosis may be required. To replace the thermostat, disconnect the cable from the negative battery terminal, drain the cooling system, and locate the thermostat housing cover by following the upper radiator hose. Loosen the hose clamp, detach the hose, and remove the housing cover fasteners and cover. Take note of the thermostat and gasket installation, remove material from the staked areas if necessary, and clean all traces of the old gasket from the surfaces. Install the new thermostat with the jiggle pin at the 12 o'clock position, and the spring end directed into the engine. Use RTV sealant if appropriate, and install a new gasket. Reattach the cover, hose, and all previously removed components, reconnect the battery, refill the cooling system, and start the engine to check for leaks and proper thermostat operation.