×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Ram 1500 Knock Sensor
Engine Knock Sensor- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
9 Knock Sensors found
Ram 1500 Knock Sensor
Knock Sensor in Ram 1500 Vehicles is as important for the proper functioning of the vehicle's engine as it helps to identify engine knock, which is among ignition timing issues. This device transmits signals to the powertrain control (PCM) that allows it to modify the ignition timing in order to reduce detonation furthermore. Usually, the Ram 1500 equipped with piezoelectric knock sensors which translate vibrations into electrical signs for the permanent evaluation of pressure maximums that gives a knocking signal. On this generation of the Ram 1500 throughout the years, there were sophisticated knock sensor which adapts the performance of the motor, the quality of the fuel and even the temperature of the engine. They are able to control ignition timing for each cylinder as well as contain boost pressure in the event that it is needed. This Ram 1500 Knock Sensor makes certain the engine runs at a level that is just a little below the knock limit, thus, boosting the vehicle's performance without causing harm to the engine.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Ram 1500 Knock Sensor at great affordable prices. Moreover, all genuine Ram 1500 Knock Sensor come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Ram 1500 Knock Sensor Parts Questions & Experts Answers
- Q: How to Disconnect the Knock Sensors on Ram 1500?A: To disconnect the knock sensors, disconnect the cable(s) from the negative battery terminal(s). For the 3.6L V6, remove the intake manifolds and disconnect the electrical connector before removing the sensor(s) mounting bolt(s). Finally, install the knock sensor(s) by reversing the removal process.
