×
- Live Chat
- 1-888-511-3595
My Garage
My Account
Cart
Genuine Ram 2500 Turbocharger
Turbo- Select Vehicle by Model
- Select Vehicle by VIN
Select Vehicle by Model
orMake
Model
Year
Select Vehicle by VIN
For the most accurate results, select vehicle by your VIN (Vehicle Identification Number).
13 Turbochargers found
Ram 2500 Turbocharger
Part Number: R8321378AA$3201.60 MSRP: $3930.00You Save: $728.40 (19%)FREE Shipping
Ram 2500 Turbocharger
Turbocharger is a centrifugal device used in the Ram 2500 vehicles, it works as a compressor that uses the exhaust gas to produce boost, the process of raising the amount of air intake into the engine. This increases volumetric efficiency and fuel efficiency while in some cases does not even lead to higher power output. Interacting with this Ram 2500 Turbocharger will results to a spinning turbine with exhaust gases whereby the spinning will increase the rate at which the compressor pushes air into the engine. Different kinds of Turbochargers have been used over the years in the Ram 2500, including, twin scroll and the variable geometry turbos. These innovations intend to minimize the lag and improve the performance in which electrically assisted turbos (E-turbos) offer better and faster response. For both petrol and diesel engines, turbocharging is advantageous, however it results to drawbacks including high temperature exhaust and failure. In a nutshell, the Ram 2500 Turbocharger is very important in addressing the current requirements of fuel economy and emission standards.
Looking for affordable and high-quality auto parts? Then you have already arrived at the proper online shop. We offer all Ram 2500 Turbocharger at great affordable prices. Moreover, all genuine Ram 2500 Turbocharger come with a manufacturer's warranty. In the long run, you would realize you have saved a lot of trouble and money with OEM parts from here.
Ram 2500 Turbocharger Parts Questions & Experts Answers
- Q: How to Replace a Turbocharger on a Ram 2500?A: Disconnect the negative battery cables and drain coolant. Remove air filter housing, hoses, tubes, wiring, and oil supply line. Remove coolant lines and engine-driven fan/shroud (2012+). Raise vehicle and support on jackstands. Remove right inner fender and engine mount. Remove exhaust bracket and V-band clamp. Lower vehicle and remove Grid Heater relay. Remove turbocharger mounting nuts and turbocharger. Clean turbocharger and exhaust manifold. Bolt turbocharger onto exhaust manifold with new gasket. Reinstall oil drain line and coolant lines. Prime center bearing with oil and install supply line. Reverse of removal for remainder of installation. Tighten turbocharger-to-exhaust manifold nuts.
