Chrysler 4656612AE ABSORBER-Suspension

You can Select Your Vehicle to check if 4656612AE fits your vehicle.

Place it in position with the studs extending up through the strut tower. Install the nuts and tighten them to the torque. Attach the strut to the steering knuckle, then insert the strut-to-steering knuckle bolts. If equipped with special camber adjusting bolts, align the marks you made in Step 3. Hold the bolts and tighten the nuts to the torque listed in the Specifications. Attach the ground strap and, if equipped, the ABS sensor harness bracket to the strut and tighten the bolt(s) securely. Install the wheel and lug nuts and lower the vehicle. Tighten the lug nuts to the torque.

To install the shock absorber, reverse the removal procedure. Tighten the upper mounting bolt nut to the specified torque. Raise the rear axle with the jack to simulate normal ride height and tighten the lower mounting bolt/nut to the specified torque.

Extend the damper rod and install the rubber bumper. Position the coil spring with the smaller coils going on first and carefully place it onto the damper shaft. Install the rubber bumper and push it all the way down. Install the upper spring seat and dust boot onto the damper shaft. Install the suspension support, aligning the support notch with the clevis bracket on the strut support. Install the nut and tighten it to the specified torque. Loosen the coil spring compressor(s) until the top coil is properly seated against the upper spring seat and suspension support. Relieve all tension from the spring compressor(s) and remove them from the coil spring. Finally, install the strut/spring assembly.