Chrysler 4721988AA Brake Bearing

You can Select Your Vehicle to check if 4721988AA fits your vehicle.

Reattach the tie-rod end, install a new cotter pin, and proceed with brake disc, pads, and caliper/adapter assembly installation. Reattach the brake hose bracket to the strut and secure the stabilizer bar to the control arms, tightening retainer fasteners. Ensure the CV joint is fully seated in the hub, install the washer and hub nut finger-tight, and proceed to reinstall the wheels, lower the vehicle, and tighten the wheel lug nuts. With an assistant applying the brakes, tighten the hub nut, and complete the assembly by installing the spring washer, nut lock, and a new cotter pin. Finally, verify proper tightness of the steering knuckle and balljoint nuts with the vehicle's weight on the suspension, and have the vehicle's front end alignment checked.

Remove the wheel, and if the vehicle has rear disc brakes, remove the caliper. Pry the grease cap from the hub, straighten and remove the cotter pin, followed by the lock and hub nut. Gently pull and push the brake drum/hub assembly to remove the outer bearing and washer. Extract the dust seal with a screwdriver and observe its installation.