Chrysler 5154214AA Wheel Bearing

You can Select Your Vehicle to check if 5154214AA fits your vehicle.

Reattach the tie-rod end, install a new cotter pin, and proceed with brake disc, pads, and caliper/adapter assembly installation. Reattach the brake hose bracket to the strut and secure the stabilizer bar to the control arms, tightening retainer fasteners. Ensure the CV joint is fully seated in the hub, install the washer and hub nut finger-tight, and proceed to reinstall the wheels, lower the vehicle, and tighten the wheel lug nuts. With an assistant applying the brakes, tighten the hub nut, and complete the assembly by installing the spring washer, nut lock, and a new cotter pin. Finally, verify proper tightness of the steering knuckle and balljoint nuts with the vehicle's weight on the suspension, and have the vehicle's front end alignment checked.

Carefully position the drum/hub assembly on the spindle to insert the grease-packed outer bearing. Install the washer and nut, tightening it slightly (up to 12 ft-lbs of torque). Spin the drum/hub forward to seat the bearings, then recheck the nut's tightness (approximately 12 ft-lbs). Loosen the nut until it's just loose, then snug it up by hand. Secure it with a new cotter pin and lock, bending the cotter pin ends flat against the nut. Install the grease cap with a hammer, place the wheel, and tighten the lug nuts securely. Check the bearings' condition by grasping the tire's top and bottom. Finally, lower the vehicle and retighten the lug nuts to complete the procedure.