Chrysler 5272119 Bracket-Engine Mount

You can Select Your Vehicle to check if 5272119 fits your vehicle.

Remove the bolt to separate the front engine mount from the block, noting that the starter must be removed for access.

1. Remove the load on the engine mounts by carefully supporting the engine and transaxle assembly with a floor jack. 2. Loosen the right insulator vertical fasteners and the front engine mount bracket-to-front crossmember bolts and nuts. 3. The left engine mount insulator is sleeved over the shaft and long support bolt to provide lateral movement adjustment. 4. Pry the engine right or left as required to achieve the proper driveaxle length. 5. Securely tighten the right engine mount insulator vertical bolts, the front engine mount bolts and nuts, and center the left engine mount insulator. 6. Finally, recheck the driveaxle length.

Use a large screwdriver or prybar to check for relative movement; if movement is noted, lower the engine and tighten the mount fasteners.

Remove the bolt to separate the transmission mount from the chassis, with the nut accessible through a hole behind the wheel assembly.