Chrysler 55076401 Button-Rear View Mirror

You can Select Your Vehicle to check if 55076401 fits your vehicle.

First of all, it becomes necessary to remove the cable that connects it with the negative terminal of batteries. Gently pull the headlight switch/rheostat panel with a trim removal tool and go on removing the electrical connectors of the power mirror switch, headlight switch, and rheostat by sliding the lock in the direction of harness, pressing the release tab and pulling the connector. To gain access for replacement of the headlight switch and rheostat or the power mirror control switch, the power mirror switch must be removed and this requires the following steps: The process of installation is as follows and it is the process in reverse of removal. Subsequently, re-secure the cable to the negative terminal of the battery, take out the center instrument panel bezel and eject the electrical connector with the help of the tab found at the rear of the hazard flasher switch. Pull out the hazard flasher switch panel from the center instrument panel bezel by unscrewing three screws and do the reverse of the above instructions for removing.

To replace the power mirror control switch, carefully pry the switch assembly from the instrument panel using a small screwdriver, then disconnect the electrical connector and remove the switch by disengaging the tabs. Installation follows the reverse of the removal process. For the accessory bezel switches, which include the rear window defogger, wiper/washer, and traction control switches, first remove the center bezel, then detach the switch bezel from the dashboard by removing the retaining screws. Disconnect the electrical connectors and remove the switch bezel housing, and to remove a switch from the bezel housing, pull the retaining clips out and slide the switch out. Installation is again the reverse of removal. For the front power window control switches, carefully pry the switch assembly from the dashboard, disconnect the electrical connector, and remove the switch, with installation being the reverse of removal. For the rear power window control switches, carefully pry the switch assembly from the center console, disconnect the electrical connector, and remove the switch, with installation following the same reverse procedure.

Push the lock toward the harness, depress the release tab, and pull off the connector.