Chrysler 4593333 Cable-Clutch Release

You can Select Your Vehicle to check if 4593333 fits your vehicle.

To release the clutch cable you need to, raise the bonnet, cover the area around the left wheel with a blanket. Subsequently, remove the air cleaner assembly and the clutch cable inspection cover from the bell housing. Slightly release the tension on the clutch cable housing to separate it from the corresponding slot of the bellhousing; detach it from the release lever. Inside the vehicle, gently press the clutch pedal so as to reach the up-stop/spacer of the clutch cable, slightly unscrew the clip that keeps the clutch cable end in position on the clutch pedal pivot pin and using thin screw driver, remove the up-stop/spacer from the clutch cable end and the clutch pedal pin. Do not exert force on the clutch cable while removing it from the dash panel so as not to damage the self-adjuster. And at the engine compartment, you can try this: hold the grommet and turn in both ways for its removal from the firewall and clutch bracket; to do it more efficiently use a screwdriver. For installation, use petroleum jelly to lubricate the clutch cable grommet, then, pass the self-adjusting through the firewall into the clutch bracket while the grommet is well seated. Inside the vehicle place the cylindrical part of the grommet over the opening in the firewall and clutch bracket and make sure that the self-adjuster fits tightly. Slip the up-stop/spacer over the clutch cable end and the clutch pedal pivot pin and then fit the retaining clip. In the engine compartment, the clutch cable end should be pulled to make it rigid and the cable housing is pressed towards the firewall with less than 25 lbs pressure required to enable the adjuster work. Attach the cable to the release lever so that the cupped washer seats, move the clutch cable housing backward and install it into the bellhousing and finally put back the clutch cable inspection cover into the bellhousing.