Chrysler 5212696 Cv Assembly-Front Wheel Drive Outer

You can Select Your Vehicle to check if 5212696 fits your vehicle.

Inspect axle shafts, CV joints and boots periodically, especially when the vehicle is raised. Common signs of failure include knocking or clicking noises when turning. To check, raise the vehicle and support it on jackstands. Look for cracks, leaks and broken bands on CV boots. Lubricant leaks can cause premature CV joint wear, so replace damaged boots immediately. Check each axle for cracks, dents, twisting and bending. Excessive movement when rotating or moving the axle may indicate worn splines or loose CV joints.

Mount the axle shaft in a vise with wood blocks and remove the boot clamps.

To inspect the entire length of each axle, grasp each axle, rotate it in both directions, and move it in and out to check for excessive movement. This will help identify any cracks, dents, signs of twisting, or bending.

Use a brass drift to drive the bearing and tripod assembly from the splined shaft.

To disassemble the outer CV joint, remove the boot clamps and push the boot back. If the CV joint was operating correctly with uncontaminated grease, replace the boot; otherwise, proceed with disassembly. Clean the axle spline area, check for wear, and clean the outer CV joint bearing assembly. Secure the housing shaft in a vise and remove the housing using a soft-face hammer, supporting the CV joint to prevent damage. Inspect all components for damage, wear, corrosion, or cracks, replacing any unserviceable parts. If needed, replace the outer housing wear sleeve.