Chrysler R0400239 Power Steering Gear

You can Select Your Vehicle to check if R0400239 fits your vehicle.

Start by disconnecting the negative battery cable and draining the power steering fluid. Then, remove the safety clip and pinch bolt on the intermediate shaft, and separate it from the steering gear shaft. Loosen the front wheel lug nuts, raise the vehicle, and remove the front wheels. Detach the tie-rod ends from the steering knuckles and mark the relationship of the front suspension cross member to the attaching bracket. Remove the front stabilizer bar mounting clamp bolts and, for ABS-equipped vehicles, remove the bolts attaching the Anti-lock Brake System hydraulic control unit. Remove the shock absorber clevis bolts, engine support bracket bolts, and the bolt attaching the engine support bracket to the transaxle mounting bracket. Support the front suspension cross member and lower it enough to remove the steering gear. Place a drain pan under the steering gear and disconnect the power steering pressure and return lines. Disconnect the pressure switch wiring harness connector and, if applicable, the speed sensing/variable assist module and solenoid control valve electrical connectors. Remove the steering gear mounting bolts and isolators, as well as the steering gear-to-cross member clamp bolts. Finally, remove the steering gear assembly from the vehicle.