Chrysler 4449668 Front Suspension Steering Knuckle Right

You can Select Your Vehicle to check if 4449668 fits your vehicle.

To start with, loosen the front hub and wheel lug nuts; then, lift the car up and take out the wheels. Remove the drive axle hub nut and disconnect the tie-rod end. Remove the brake pads and caliper, and detach the brake disc. Remove the steering knuckle-to-strut bolts, and pull off the knuckle and hub assembly. Check for damage on the knuckle and ensure that bearings are in good condition. Replace the hub and bearing assembly (for models 1991+). Lubricate CV joint seal and hub grease seal; then reposition the knuckle and hub assembly. Reattach tie-rod end; reinstall brake disc-pads. Reattach the brake hose bracket; and stabilizer bar. Mount wheels again after lowering the vehicle; finally tighten wheel lug nuts lastly check the vehicle's front-end alignment.