Chrysler 4877270AA Brake Mastr Cylinder

You can Select Your Vehicle to check if 4877270AA fits your vehicle.

To install the new master cylinder, bench bleed it first by mounting it in a vise and attaching bleeder tubes to the outlet ports. Fill the reservoir with recommended brake fluid and slowly push the pistons into the master cylinder to expel air into the reservoir, preventing air from being drawn back in. Remove the bleed tubes, install plugs, and the reservoir cap. Put a new vacuum seal on the master cylinder where it mates with the power booster. Install the master cylinder over the power brake booster studs and finger-tighten the nuts. Thread the brake line fittings into the master cylinder, ensuring they don't strip. Fully tighten the mounting nuts and brake line fittings. Fill the reservoir with fluid, then bleed the master cylinder and brake system with an assistant. Loosen the fittings, allowing air and fluid to escape, and repeat this on both fittings until the fluid is clear of air bubbles. Use rags to catch spilled brake fluid to avoid damaging painted surfaces. After bleeding, rinse the area under the master cylinder with clean water. Finally, test the brake system's operation carefully before normal vehicle use.

To remove the master cylinder, start by pumping the brake pedal with the engine off to relieve the vacuum inside the power brake booster, preventing contaminants from entering it. Remove the battery and use a syringe to siphon the brake fluid from the master cylinder reservoir. Place rags under the fluid fittings and prepare to cap or bag the line ends when disconnected. Loosen the line fittings with a flare-nut wrench, move the lines slightly, and quickly plug the ends. Thoroughly clean the mounting area, remove the nuts attaching the master cylinder to the power booster, and carefully pull it off. If necessary, transfer roll pins from the old reservoir to the new master cylinder, ensuring new seals are installed between the master cylinder and reservoir.

Reinstall the lines, hand-tighten the flare nuts carefully to avoid cross-threading, and then securely tighten them with a flare-nut wrench. Complete the process by filling the master cylinder reservoir and bleeding the brakes to ensure proper brake function.