Chrysler V2012560AB Rear Disc Brake Pad Kit

You can Select Your Vehicle to check if V2012560AB fits your vehicle.

This procedure applies to both the front and rear disc brakes. Begin by removing the cap from the brake fluid reservoir. Loosen the wheel lug nuts, raise the vehicle, and support it securely on jackstands, blocking the wheels at the opposite end. Remove the wheels and work on one brake assembly at a time, using the assembled brake for reference if necessary. Inspect the brake disc carefully; if machining is necessary, remove the disc to also take out the pads. For floating calipers (non-SRT models), push the piston back into its bore using a C-clamp, ensuring the master cylinder fluid does not overflow. Follow the accompanying illustrations for the pad replacement procedure, ensuring to stay in order and read the captions. When reinstalling the caliper, tighten the mounting bolts to the specified torque, then firmly depress the brake pedal a few times to bring the pads into contact with the disc, checking the brake fluid level and operation before normal service. For fixed calipers (SRT models), wash the caliper and surrounding components with brake system cleaner, then tap the lower caliper guide pin inward and remove it, followed by the pad retainer. Drive out the upper caliper guide pin and, for 2016 and later models, remove the caliper center support bolt if equipped. Pull the inboard brake pad from the caliper, ensuring only one pad is removed at this step. Use prybars or screwdrivers to slowly push the caliper pistons into the bores, being cautious to prevent one piston from being forced out while the other is pushed in. Prepare each new brake pad with a small amount of copper-based brake paste on the edges that contact the caliper and backing plates, then position the new inboard brake pad into the caliper. Pull the inner brake pad from the caliper and repeat the piston retraction for the outer pistons. Prepare the new outer brake pad and position it into the caliper. If equipped, install the caliper center support bolt and tighten it to the specified torque. Install the upper guide pin and place the spring-steel pad retainer, then press the bottom end of the retainer and install the lower guide pin. Repeat the procedure on the opposite wheel, and after completing the job, firmly depress the brake pedal a few times to bring the new pads into contact with the disc, checking the brake fluid level and operation before normal service.

Firmly depress the brake pedal a few times to bring the pads into contact with the disc. Check the level of the brake fluid adding some if necessary. Check the operation of the brakes carefully before placing the vehicle into normal service.

Firmly depress the brake pedal a few times to bring the pads into contact with the disc. Check the level of the brake fluid adding some if necessary. Check the operation of the brakes carefully before placing the vehicle into normal service.

Use an AC-clamp to push the piston back into its bore.