Chrysler 4411977 Ring Pkg

You can Select Your Vehicle to check if 4411977 fits your vehicle.

Before fitting new piston rings, examine the ring end clearance, to be assured that the piston ring side clearance has been checked and approved. Spread the piston/connecting rod assemblies and the new rings in a manner that ensures that each piston or cylinder is paired with the same piston and cylinder during end gap measurement or during engine assembly. Place the top ring into the first cylinder, aligning it to the cylinder walls by using the piston and then ascertain the end gap and whether or not they meet their specifications by using a feeler gauge. If the gap is incorrect, go on to ensure that the appropriate rings are correct. If the gap is too small, then open it gently with the help of a file, always remembering to file from the outside in. Excess end gap is not too important provided it is more than 0.040-inch (1mm), at this check the rings for correctness. Do the same for every ring in all cylinders, make sure the rings, Pistons and cylinders are compatible. Once the end gaps are checked and corrected, put them on the pistons; oil control ring which is made up of three parts is the first one. Place the spacer/expander into the groove, and put the lower side rail into place with the size mark and manufacturer's stamp in the upper side of the rail In some engines, this is best done with the help of a piston ring installation tool, but in others, it is possible to do this with fingers. When fitting the three components of the oil ring make sure both side rails rotate easily in the groove and that the gaps are positioned at the end. Then the middle ring should be fitted and placed in such a manner that the mark is in the upper part of the piston, and the inner circle slipped into the middle groove of the piston with the help of a piston ring installation tool should not be expanded much. Finally apply the top ring in the same way as to ensure that the identifying mark is facing up, this is followed by the same process for the remaining pistons and rings.

To measure the end gap, use feeler gauges between the ends of the ring until a gauge equal to the gap width is found, ensuring the feeler gauge slides with slight drag.