Chrysler 4896003AA Sensor-Map

You can Select Your Vehicle to check if 4896003AA fits your vehicle.

To remove the MAP sensor on a V6 engine, unlock and disconnect the electrical connector, then rotate the sensor counterclockwise 1/4-turn and pull it out. Inspect the 0-ring and replace if necessary. To install, reverse the removal steps. On a V8 engine, the MAP sensor is located near the firewall. Disconnect the electrical connector, rotate the sensor 1/4-turn counterclockwise and remove it. Inspect the 0-ring and replace if necessary. To install, place it in position, insert it into the mounting hole and turn it 1/4-turn clockwise. Reverse the removal steps to complete installation.

Disconnect the cable from the negative terminal of the battery. Locate the MAP sensor, which is mounted to the rear of the upper intake manifold, near the coolant reservoir, and disconnect the MAF sensor electrical connector. Remove the MAF sensor retaining screws and take out the sensor. Installation is the reverse of removal.

The MAP sensor is on the intake manifold of all engines. To remove the MAP sensor, disconnect the cable from the negative terminal of the battery and then disconnect the electrical connector from the sensor. Slide the red lock to the right, depress the release tabs, and disconnect the electrical connector. Remove the sensor retaining screws and take out the sensor. To install, reverse the removal process.

Disconnect the negative battery cable. The MAP sensor is located on the front right corner of the intake manifold. Disconnect the electrical connector from the MAP sensor. Remove the retaining screws of the MAP sensor and then detach the sensor from the intake manifold, ensuring to discard the old O-rings and replace them. Whether installing the old MAP sensor or a new unit, new O-rings should be installed on the sensor. Installation is the reverse of removal, taking care not to damage the O-rings during the process.

To remove the MAP sensor, disconnect the cable from the negative terminal of the battery and then disconnect the electrical connector from the sensor. Slide the red lock to the right, depress the release tabs, and disconnect the electrical connector. Remove the sensor retaining screws and take out the sensor.

To install the MAP sensor, place it in position, insert it into the mounting hole in the intake manifold, and turn it 1/4-turn clockwise. The installation process is otherwise the reverse of removal.

For the throttle body temperature sensor, remove the air cleaner, disconnect throttle cables, remove the accelerator cable bracket, unplug the electrical connector from the sensor, remove the sensor, apply heat transfer compound, install the sensor securely, and reverse the steps for reinstallation.