Chrysler 5064358AB Speaker

You can Select Your Vehicle to check if 5064358AB fits your vehicle.

To eject the radio, the ignition system should be switched On and the Scan and Set buttons pushed simultaneously. Pull out cables from negative battery terminals. Start by removing centre instrument panel on a bezel by pulling back it using plastic trim tool and unscrewing the screws beneath upper storage tray. Slowly draw bezel backward until it comes off wiring. Take out four screws that hold down radio then pull it through dashboard; disconnect electrical connectors antena cable too. To remove speakers, remove cables from negative battery terminals Remove door trim panel for front door speakers and take out four screws which held speaker in place Unplug the connector to remove speaker Revove covers near windshield in instrument panel for center instrument panel speaker and end speakers then open them up to reveal screwes at bottom where they are attached to one of these things that are put together so they can produce sound like music or words coming out through their mouths instead having none outside (I am not sure this is what you mean here but I would expect something similar) Take off top cover connecters At rear cab side or rear door of vehicle , get rid of B-pillar lower trims or rear door trim panels and undo three screws attaching loudspeakers Pushing each up, unplug wiring from Woofer as well as undo mountings bolts thereof For headliner speaker on quad cab models, use a long narrow blade screw driver wrapped with cloth tape to pry off speaker cover above it Disconnecect two clips securing it then detach harness for wires before extracting.

To remove the instrument panel speakers, you need to remove the instrument panel top cover and speaker mounting screws.

To remove the subwoofer, put the right rear seat into the Up position on quad cab models. Disconnect the wiring from the subwoofer and remove the mounting bolts. Remove the subwoofer.

To remove the rear cab side speakers or rear door speakers, disconnect the B-pillar lower trim or the rear door trim panel and remove the three speaker mounting screws. Pull out the speaker and disconnect the electrical connector.

To remove the radio, start by turning the ignition system On and pushing the Scan and Set buttons simultaneously. Disconnect the cable(s) from the negative battery terminal(s). Remove the center instrument panel bezel by removing the screws under the upper storage tray and using a plastic trim tool to pull it rearward. Carefully pull the bezel to the rear and disconnect the wiring. Remove the four radio mounting screws and pull the radio out of the dash. Disconnect the electrical connectors and the antenna cable.

To remove the headliner speaker on quad cab models, use a plastic trim tool or a screwdriver wrapped with tape to pry off the speaker cover. Remove the two clips securing the speaker and disconnect the wiring harness.

To remove the front door speakers, disconnect the cable(s) from the negative battery terminal(s). Disconnect the door trim panel and remove the four speaker mounting screws. Pull out the speaker and disconnect the electrical connector.