Chrysler 4656304 Front Suspension Coil Spring

You can Select Your Vehicle to check if 4656304 fits your vehicle.

Start by removing it and reinstalling the clevis bracket on the shock absorber. Clamp the shock absorber in a vertical position in a vise. Next, compress the coil spring using a coil spring compressor and remove the shock absorber damper rod nut. Take off the damper rod washer, upper control arm mounting bracket, and isolator bushings from the damper rod. Remove the shock absorber upper isolator bushing, lower isolator bushing, and sleeve from the upper control arm mounting bracket. Then, remove the upper spring isolator from the mounting bracket and the lower isolator bushing from the damper rod sleeve. Remove the washer and dust shield from the shock absorber assembly, followed by the compressed coil spring. Take off the jounce bumper and sleeve from the shock absorber assembly, as well as the coil spring isolator from the lower spring seat on the shock absorber.

Connect the assembly to the upper control arm mount and install it into the shock tower. Align the locating pins and mounting holes and tighten the four bolts. Install the clevis on the shock absorber and tap it until properly aligned and fully seated against the locating tab. Install the bolt and tighten it. Install the clevis-to-lower control arm bolt without tightening it. Install the upper ball joint into the steering knuckle, tighten the castle nut, and install a new cotter pin. Install the speed control routing cable on the steering knuckle. Use a floor jack to raise the lower control arm to simulate normal ride height and tighten the shock absorber clevis-to-lower control arm bolt. Install the wheel and lug nuts, lower the vehicle, and tighten the lug nuts.

Guide the shock absorber into place, insert the upper mounting studs through the holes in the shock tower, and tighten the nuts. Connect the lower end of the shock absorber to the knuckle and tighten the bolt/nut. Install the wheels, lower the vehicle, and tighten the lug nuts. Finally, tighten the upper mounting nuts and install the cap.