Chrysler 5006729AA Front Coil Spring

You can Select Your Vehicle to check if 5006729AA fits your vehicle.

Check the cost and availability of parts.

Extend the damper rod to its full length and install the rubber bumper. Install the dust boot onto the damper. Carefully place the coil spring onto the damper, aligning it with the reference marks made during disassembly. Install the upper spring isolator and seat onto the damper shaft, again noting reference marks. Install the upper mount to the damper shaft, noting its alignment. Install the nut on the damper shaft and tighten it. Loosen the coil spring compressor until the top coil is properly seated against the upper spring seat and upper mount. Relieve all tension from the spring compressor and remove the tool from the coil spring. Finally, install the strut/spring assembly.

Start by raising the rear of the vehicle and supporting it securely on jackstands. Then, support the axle with a jack and remove the rear wheels. If the vehicle is equipped with automatic air suspension, disconnect the fitting for the height sensor or the air lines from the shock absorbers. Remove the lower and upper shock mounting bolts and detach the shock absorber.