Chrysler 68051891AA Fuel Tank Rear

You can Select Your Vehicle to check if 68051891AA fits your vehicle.

To remove the fuel tank, start by relieving the fuel system pressure and disconnecting the cable from the negative battery terminal. If possible, drain as much fuel as you can from the tank. Remove the lower cushion from the back seat and the foam pad covering the access covers for the fuel pump/fuel level sensor module and the fuel filter/fuel pressure regulator/fuel level sensor. Disconnect the electrical connector from the fuel pump/fuel level sensor module. Loosen the rear wheel lug nuts, raise the vehicle, and remove the rear wheels. Remove the left rear inner fender shield and disconnect the quick-connect fittings for the filler neck vent line, EVAP vent line, and fuel supply line in the rear wheel wells. Disconnect the fuel filler neck hose and remove the under-body splash shields. Remove the exhaust pipe(s) and the driveshaft, and if equipped, remove the heat shield from under the vehicle. Support the fuel tank, remove the fuel tank retaining strap bolts, and lower the fuel tank carefully, making sure all connections are disconnected. For installation, transfer components to the new fuel tank if needed, and tighten the fuel tank strap bolts securely. After installation, activate the fuel pump to build up fuel pressure, and check for any fuel leakage.

Yes, explosive fumes may still be present inside the fuel tank, so extra caution should be taken in a garage with a gas-type appliance.

Begin by relieving the fuel system pressure and disconnecting the cable from the negative battery terminal.