Chrysler 4891738AA Valve-Linear PURGE

You can Select Your Vehicle to check if 4891738AA fits your vehicle.

The EVAP system prevents fuel vapors from escaping into the atmosphere. Symptoms of a faulty system include a strong fuel odor. The EVAP canister, NVLD assembly, and purge solenoid are located in the right rear corner of the vehicle and engine compartment, respectively. To inspect or replace the components, the vehicle needs to be raised and the right rear wheel and wheel well splash shield need to be removed. The NVLD filter, NVLD pump, and EVAP canister can be detached from their mounting brackets. The EVAP line can be disconnected from the canister.

The Evaporative Emissions Control (EVAP) is the system which controls emission of fuel system vapors, which contain We, unburned hydrocarbons. During hot days, gases formed within the fuel tank build upon the fuel and when pressure builds up, the fuel vapour vent valve and the fuel vapour control valve directs the fuel vapours to the EVAP canister for a temporary storage until it is burnt by the engine. In certain circumstances, PCM turns on fuel canister purge solenoid and with the help of intake manifold vacuum, fuel vapour enters into induction air/fuel mixture to supply for combustion. EVAP canister is installed in the right rear corner of the automobile and it is of activated charcoal type which does not require any service. The Natural Vacuum Leak Detection (NVLD) assembly located in the same area, is designed to measure the temperature of unburned hydrocarbon vapours; if the pressure temperature relationship is abnormal then it sends a signal to the PCM to set a Diagnostic Trouble Code (DTC). The canister purge solenoid controls the flow of the vapor from the canister to the intake manifold and this is controlled by the PCM. A defective EVAP system shows some symptoms such as a strong smell of fuel especially in a hot climate; there may be a problem with the filler cap, the hoses connections or the canister. On component replacement, the electrical connectors are disconnected, hoses get labeled and several components are removed whilst on installation it is just the opposite of removal. For the 2007 and later models, the EVAP filter and the Evaporative Emission System Monitor (ESIM) are an integrated part of the canister in the car and the Fuel Tank Pressure (FTP) sensor is in the fuel tank vent tube which, similar to the above explained, has to be disconnected to check.

The EVAP system prevents fuel vapors from escaping into the atmosphere. Symptoms of a faulty system include a strong fuel odor. The EVAP canister, NVLD assembly, and purge solenoid are located in the right rear corner of the vehicle and engine compartment, respectively. To inspect or replace the components, the vehicle needs to be raised and the right rear wheel and wheel well splash shield need to be removed. The NVLD filter, NVLD pump, and EVAP canister can be detached from their mounting brackets. The EVAP line can be disconnected from the canister.

The EVAP system prevents fuel system vapors from escaping into the atmosphere. Vapors trapped inside the fuel tank expand on warm days and are routed through the fuel vapor vent valve and the fuel vapor control valve to the EVAP canister, which stores the vapors temporarily until they can be consumed by the engine.