Jeep 4868999AD Battery-Storage

You can Select Your Vehicle to check if 4868999AD fits your vehicle.

Disconnect and isolate the remote battery cable. Loosen the left front wheel lug nuts, raise the front of the vehicle and support it securely on jackstands, then remove the wheel. Remove the push pins and the inner-fender splash shield from the left front wheel well. Remove and isolate the negative battery cable before doing the same to the positive battery cable. Remove the battery retaining bracket nut, then remove the bracket and the battery from the wheel well. Be careful. 2015 and later models: Open the hood, disconnect the intelligent Battery Sensor (lBS) connector, then loosen the nut and disconnect the cable from the negative battery terminal. Loosen the nut and disconnect the cable from the positive battery terminal. Remove the battery cover by pulling it straight up. Remove the battery hold-down clamp. Lift the battery up and out of the engine compartment. If you are replacing the battery, make sure you get one that's identical, with the same dimensions, amperage rating, cold cranking rating, etc. Installation is the reverse of removal. Always connect the positive cable first and the negative cable last. Battery tray: Remove the battery. Remove the four battery tray mounting bolts retaining the tray to the left front frame rail. Remove the battery tray through the wheel opening. Thoroughly wash the battery tray in clean water, then dry it with compressed air. Installation is the reverse of removal. 2015 and later models: Loosen the left-front wheel lug nuts, then raise the front of the vehicle and support it on jackstands. Remove the left-front wheel and inner fender splash shield. Also remove the engine under cover. Remove the fuse box assembly mounting bolts and position it to the side. Remove the Powertrain Control Module (PCM) mounting bolts, then position it to the side. If necessary, also remove the PCM mount for better access. Detach any wiring harness clips from the battery tray, then remove the battery tray mounting bolts - accessed by working from the engine compartment, fenderwell, and from below the vehicle. Remove the battery tray, rotating it as necessary. Installation is the reverse of removal.

Always disconnect the negative cable first and reconnect it last to avoid shorting.

For maintenance-type batteries, it advises checking the electrolyte level and adding distilled water if needed.

Avoid using chargers with ratings exceeding 1/10th the battery's amp/hour rating. Rapid boost charges should be reserved for emergencies.

Disconnect and isolate the remote battery cable. Loosen the left front wheel lug nuts, raise the front of the vehicle and support it securely on jackstands, then remove the wheel. Remove the push pins and the inner-fender splash shield from the left front wheel well. Remove and isolate the negative battery cable before doing the same to the positive battery cable. Remove the battery retaining bracket nut, then remove the bracket and the battery from the wheel well. Be careful.

The battery is located in the engine compartment, and the battery cables are accessible after opening the hood.

To disconnect the battery, first disconnect the Intelligent Battery Sensor (IBS) electrical connector from the negative cable (if equipped), then loosen the negative battery cable clamp nut, lift the cable off the negative terminal, and secure it aside to prevent accidental reconnection. It is important to note that whenever the battery is disconnected on 2015 and later models, the Intelligent Battery Sensor (IBS) electrical connector must be disconnected prior to disconnecting the negative cable from the battery post.

Routine battery maintenance is crucial for these vehicles to ensure reliable starts.

Remove the air filter housing fresh air duct by rotating the retaining clips and taking out the duct. Disconnect the negative battery cable, followed by the positive cable, from the battery. Unscrew the bolt and remove the hold-down clamp from the bottom edge of the battery. Lift out the battery using special battery removal tools available at auto parts stores for easier handling. Installation involves connecting the positive cable first, followed by the negative cable. If equipped, transfer the battery insulator to the new battery when replacing.

Memory-saver devices can be used by plugging them into the cigarette lighter and connecting them to a spare battery, providing sufficient current to maintain audio unit security codes, PCM memory, and power to always hot circuits like the clock and radio memory circuits.