Jeep BD086525AA Battery-Storage

You can Select Your Vehicle to check if BD086525AA fits your vehicle.

To disconnect the battery, loosen the cable end nut of the remote negative terminal, disconnect the cable from the remote ground terminal, attach the plastic insulator portion of the cable to the stud, and reinstall the nut.

Loosen the left-front wheel lug nuts, then raise the front of the vehicle and support it on jackstands. Remove the left-front wheel and inner fender splash shield. Also remove the engine under cover. Remove the fuse box assembly mounting bolts and position it to the side. Remove the Powertrain Control Module (PCM) mounting bolts, then position it to the side. If necessary, also remove the PCM mount for better access. Detach any wiring harness clips from the battery tray, then remove the battery tray mounting bolts - accessed by working from the engine compartment, fenderwell, and from below the vehicle. Remove the battery tray, rotating it as necessary. Installation is the reverse of removal.

Before disconnecting the battery, it is important to remove the key from the ignition and keep it with you to prevent it from getting locked inside if the power door locks engage accidentally when the battery is reconnected. Alternatively, memory-saver devices can be used to avoid these problems.

Unscrew the bolt and remove the hold-down clamp from the bottom edge of the battery. Lift out the battery using special battery removal tools available at auto parts stores for easier handling.