Jeep L0007440 Bulb

You can Select Your Vehicle to check if L0007440 fits your vehicle.

For replacing the front turn signal/parking light/side marker light bulbs, remove the headlight housing as well as the bulb holder. After that, take out the old bulb and put in a new one. For the high-mounted brake light and cargo light bulbs, detach the housing while disconnecting its electrical connectors. Then you should twist and remove it from the bulb holder so that you can be able to pull out its old bulb and insert a new one. To replace fog lamp bulbs, unplug wiring from it turning counterclockwise to remove it from a hole in which it was placed. For license plate light bulbs, untwist and remove it off from its holder after that you can be able to pull out an old bulb and insert a new one for replacement purposes. Mirror mounted lights are LED lights; therefore replacing them involves fitting a new LED assembly if they become faulty. The rear fender lights need to be gently pushed or pulled out of their lens before being twisted off from their bulb holders allowing pulling out of an old bulb and inserting a new one instead. To change tailgate lights unscrew screws on this side of light lens so that you get chance of removing it from there with ease. This is how you take off an old bulb by twisting down its holder while installing another one in its place so far as your vehicle's taillight assembly is concerned. Bed storage bin Lightbulbs have their lens removed by taking such lens off by twisting around at its holder level;thereafter,you will be able to pull out an old bulb before fixing anewone in position.The dome light will require you push down the sides of this cover then detach all parts including these bulbs themselves using hands carefully.Insert anewbulb of suitable size properly back into place.To replace glove box lighting facility,it should simply be slid straight direction for removal then another piece inserted into opposite groove whereit cameoff.These reading lamps need to have the sides pried open and then slide it forward until you can be able to remove one end from them.Put in a LED bulb of same size or wattage as that which is being replaced.As forthese vanity light bulbs, the lens has to be pried off from the top part of light assembly so that afterthat you can pull out its old bulb gently and replace it with anewone.Such light fixtures are devised in such a way that their covers are pushed down thereby enabling users to withdraw all lamps for replacement.There is an existing tab on the console storage bin light bulb lens that should be pressed downwards before taking entire lamp out.Disconnect all wires, slide cover sideways revealing one small globe. Pull out old one and insert another new bulb in its place.

For the instrument cluster illumination bulbs, they are not separately serviceable. However, to replace the reading lights, pry off the lens cover and remove the bulb. To replace the dome light, pry off the dome light lens cover and remove the bulb.

To replace the glove box light bulb, pull it straight out and insert the new one.

To replace the dome light bulb, pry down the side of the dome light lens and remove the bulb from the housing. Insert the new bulb and reassemble.