Jeep 5011343AA Air Conditioner And Heater Control

You can Select Your Vehicle to check if 5011343AA fits your vehicle.

Disconnect the negative cable from the battery. Detach the instrument panel bezel. Remove the radio. Remove the four mounting screws from the A/C switch. Unplug the electrical connectors. Detach the vacuum connector by bending back the locking tab. Release the control cable locking tab with a screwdriver. Detach the ring on the end of the control cable from the arm on the bottom of the control panel. To install the control, reverse the removal procedure. Disconnect the cable from the negative battery cable. Roll down the glove box from the instrument panel. Reach through the glove box opening in the instrument panel and unplug the two halves of the connector for the heater/air conditioning vacuum harness. Remove the center bezel from the instrument panel. Release the vacuum harness push-in retainer from the instrument panel. Remove the four retaining screws from the A/C switch. Pull out the A/C switch assembly and unplug the electrical connectors from the backside of the control assembly. Reach through the glove box opening and support the vacuum harness while removing the A/C switch assembly. Installation is the reverse of removal.