Make sure this part fits

Jeep 4589650AD Power Door Lock Actuator W/Latch Assembly

2012-2017 Jeep 4589650AD

Customer Questions & Expert Answers (7)
Mopar 4589650AD Power Door Lock Actuator W/Latch Assembly
  • Part Description
    Latch-Rear Door
  • Replaced By
    4589650AE
  • Manufacturer
    Mopar
Make sure this part fits
$146.46 MSRP: $219.00
You Save: $72.54 (34%)
1
ADD TO CART
  • Related Parts
  • Product Specifications
  • Vehicle Fitment
  • Customer Questions & Expert Answers
  • Product Specifications

    BrandGenuine Jeep
    Manufacturer Part Number4589650AD
    Part DescriptionLatch-Rear Door
    Item Dimensions6.4 x 4.1 x 3.9 inches
    Item Weight1.60 Pounds
    ConditionNew
    ManufacturerMopar
    SKU4589650AD
    WarrantyThis genuine Mopar part is guaranteed by Mopar's factory warranty.
    Shipping & ReturnShipping Policy Return Policy
    Warning: California’s Proposition 65
  • Vehicle Fitment

    Year Make Model Engine Important vehicle option details
    2012-2017 Jeep Compass4 Cyl 2.0L, 4 Cyl 2.4LLatitude 4WD, Latitude FWD, Limited 4WD, Limited FWD, Sport 4WD, Sport FWD
    2012-2016 Jeep Patriot4 Cyl 2.0L, 4 Cyl 2.4LLatitude 4WD, Latitude FWD, Limited 4WD, Limited FWD, Sport 4WD, Sport FWD
  • Customer Questions & Expert Answers

    Q:
    This part will not fit my vehicle. Can you provide me with the part number for the bracket that will fit? TN. Posted by MoparPartsGiant Specialist
    A:
    You can Select Your Vehicle to check if 4589650AD fits your vehicle.
    Posted by MoparPartsGiant Specialist
    Q:
    How do you remove the Door Handle,Door Latch and Door Lock Cylinder on Ram 3500? Posted by Customer
    A:
    Remove the cover plate first by removing the door trim panel. For crew cab models, also remove the rear speaker and access panel from the back of the door. In case of club cab models, remove both little access plugs situated near the top middle part of the door. Then release glass clips at its bottom edge from window regulator lift plates. Lift up glass to full closed position and tape across top of door to hold in place. At last, disconnect main wiring connector in this door and pull rubber wiring grommet off this door jamb. Using a small screwdriver gently press lock tabs inward until they are flush and coax connector out of hole in metal. The control rods will be disconnected after removing the access plate from outside handle. To get wire harness loose from front edge, take out two screws on it. The screw on lower belt channel is removed in standard cab models only .Door latch screws should come off from edge of door as well ,remove bolts around perimeter of carrier plate then lift it off .After removal of carrier plate, proceed similarly for removing latch and disconnecting wiring from door latch .Detach bracket and take off latch; it is removed by doing so.Step2:To remove the outside handle, you must first unscrew the bolts on the inner side, then gently pull the handle outward.Step3:Disconnect 2 control rods from handle, unscrew inside bolts through inner side then remove outer handle.To have inside handle out you need to pull trims panel down that will let you detach control rod away from these handles.Mounting screw at top hinge can be removed.
    Posted by MoparPartsGiant Specialist
    Q:
    How should the door and trunk locks be lubricated for the 2018 Ram 1500? Posted by Customer
    A:
    They should be lubricated with spray-on graphite lubricant.
    Posted by MoparPartsGiant Specialist
    Q:
    How often should the hinges and latch assemblies on the doors, hood, and trunk be lubricated for the 2012 Ram 2500? Posted by Customer
    A:
    Once every 3000 miles or every three months.
    Posted by MoparPartsGiant Specialist
    Q:
    What type of lubricant should be used for the hinges and latch assemblies for the 2011 Ram 3500? Posted by Customer
    A:
    A few drops of light oil or lock lubricant.
    Posted by MoparPartsGiant Specialist
    Q:
    What are the steps for removing the inside handle and lock cylinder for the 2015 Ram 2500? Posted by Customer
    A:
    To remove the inside handle, remove the door trim panel and disconnect the control rod from the handle. Remove the mounting screw from the top of the handle hinge, then remove the handle. To remove the lock cylinder, remove the outside door handle and pull the lock cylinder from the inside of the door handle.
    Posted by MoparPartsGiant Specialist
    See expert answers on similar Door Latch Assembly
    Q:
    What initial steps should be taken before removing the carrier plate for the 2015 Ram 1500? Posted by Customer
    A:
    To remove the carrier plate, start by removing the door trim panel. On crew cab models, also remove the speaker and access panel at the rear of the door. On club cab models, remove the two small access plugs in the upper center of the door.
    Posted by MoparPartsGiant Specialist
    See expert answers on similar Door Latch Assembly
    If you have any questions about this product, please don't hesitate to ask us. We will be happy to help you!

Genuine Mopar Part 4589650AD, the Right Choice

To ensure reliability, purchase Mopar part # 4589650AD Power Door Lock Actuator W/Latch Assembly. It is sometimes referred to as Jeep Door Lock Actuator, Jeep Door Latch Assembly. For Mopar owners with dreams of keeping their vehicles running in prime condition, choosing OEM parts is a smart decision. Meticulously crafted, these parts follow strict factory specifications and are manufactured in top-notch facilities with advanced technologies. Furthermore, they undergo rigorous testing to ensure durability and safety, making them a reliable choice for Mopar owners. This part fits specific Jeep Compass, Patriot models.

MoparPartsGiant.com is a leading supplier of genuine Mopar parts and accessories such as Mopar 4589650AD Power Door Lock Actuator W/Latch Assembly. Wondering where to find exceptional quality and affordable OEM Mopar parts? You have already come to the right place. Our website boasts a huge selection of genuine Mopar parts at the most economical prices possible. What's more, all parts come with a manufacturer's warranty. For detailed Jeep parts information, click here.

Why choose Mopar Parts Giant

  • Dedicated Service

    Your complete satisfaction is our #1 goal

  • Lowest Prices

    Best deals on genuine OE parts from dealerships

  • Fast Delivery

    Orders are processed and delivered promptly