Jeep 4364874 Link

You can Select Your Vehicle to check if 4364874 fits your vehicle.

Do not bypass a fuse with metal or aluminum foil as serious damage to the electrical system could result. The fuse block is located below the dash, to the left of the steering column and directly above the hood release handle, behind a panel. To expose the fuse block, put your finger in the notch at the bottom of the panel and pull it back sharply. With the ignition off, remove each fuse in turn by grasping it and pulling it from the block. Replace any blown fuse with a new one of the same value by pushing it into place, then install the cover panel. If the fuses are not blown and the headlights or other components are inoperable, check the fusible links located in the wiring harness adjacent to the left suspension strut tower. Before replacing a fusible link, determine the reason it burned out, as replacing it without addressing the cause could lead to serious damage. Determine the proper gauge for the replacement link and obtain the new link or link wire from your dealer. Disconnect the negative battery cable and cut off all remaining burned out fusible links. Strip off one inch of insulation from both ends of the new fusible link and the main harness wire. Install the new fusible link by twisting the ends securely around the main link wire, ensuring that on multiple links, the replacement wire is connected to the main wires beyond the connector insulators of the old link. Solder the wires together with non-acid core solder, and after the connection has cooled, wrap the splice with at least three layers of electrical tape.

If a replacement fuse fails immediately, it should not be replaced again until the underlying issue is identified and resolved, typically due to a short circuit caused by a broken or deteriorated wire.

The electrical circuits of the vehicle are safeguarded by a combination of fuses, circuit breakers, and fusible links.

Each fuse is tailored to protect a specific circuit, which is indicated on the fuse panel.

If an electrical component has failed, the first check should be the fuse.