Jeep BD034700AA Storage

You can Select Your Vehicle to check if BD034700AA fits your vehicle.

Corrosion can be removed with a baking soda solution. After removing the corrosion, rinse the area and cover damaged metal parts with zinc-based primer and paint.

Remove the battery. Remove the four battery tray mounting bolts retaining the tray to the left front frame rail. Remove the battery tray through the wheel opening. Thoroughly wash the battery tray in clean water, then dry it with compressed air. Installation is the reverse of removal.

The battery is located in the engine compartment, and the battery cables are accessible after opening the hood.

The battery is mounted behind the lower front portion of the left front fender, and the remote positive and negative terminals are located in the engine compartment at the left strut tower.

Open the hood, disconnect the intelligent Battery Sensor (lBS) connector, then loosen the nut and disconnect the cable from the negative battery terminal. Loosen the nut and disconnect the cable from the positive battery terminal. Remove the battery cover by pulling it straight up. Remove the battery hold-down clamp. Lift the battery up and out of the engine compartment. If you are replacing the battery, make sure you get one that's identical, with the same dimensions, amperage rating, cold cranking rating, etc. Installation is the reverse of removal. Always connect the positive cable first and the negative cable last.

Routine battery maintenance is crucial for these vehicles to ensure reliable starts.

Disconnect the negative battery cable first, followed by the positive cable, to avoid shorting the battery.

Remove the battery, followed by the tray liner if one exists. Finally, remove the battery tray fasteners and lift the tray out.

Some systems on the vehicle require battery power to be available at all times, either to maintain continuous operation or to maintain control unit memory.