Jeep 5003461AA VALVECORE-A/C Line

You can Select Your Vehicle to check if 5003461AA fits your vehicle.

It is not necessary to discharge the air conditioning system in order to replace the pressure switch. Disconnect the cable from the negative battery terminal. Unplug the electrical connector from the air conditioning pressure switch and unscrew the switch. Unscrew the pressure switch from the line, being careful not to damage the refrigerant line, and discard the O-ring seal. Lubricate a new R-134a or R-1234yf compatible O-ring seal with the appropriate refrigerant oil and place it into position. Screw the new switch onto the refrigerant line valve until hand-tight, and then tighten it securely. Reconnect the electrical connector and the battery cable.

The air conditioning pressure switch is located on the high pressure line. To replace the switch, begin by disconnecting the cable(s) from the negative battery terminal(s). Then, unplug the electrical connector from the pressure switch and unscrew the old switch. Installation is the reverse of removal, making sure to lubricate the 0-ring with clean refrigerant oil before installing the new switch.

Screw the new switch onto the refrigerant line valve until hand tight, and then tighten it securely.

To replace the switch, start by disconnecting the cable(s) from the negative battery terminal(s). Then, unplug the electrical connector from the pressure switch and unscrew the old switch. Before installing the new switch, lubricate the 0-ring with clean refrigerant oil. Screw the new switch onto the refrigerant line until hand tight, then tighten it securely. Finally, reconnect the electrical connector and the negative battery cable(s).