Mopar 68057365AB ABSORBER Pkg-Suspension

You can Select Your Vehicle to check if 68057365AB fits your vehicle.

Visually inspect the steering and suspension components for damage and distortion, including seals, boots, bushings, and leaks.

Certainly. For 4WD models with a solid front axle, start by loosening the driveaxle/hub nut and wheel lug nuts on 1500 4WD models. Then, raise the front of the vehicle and securely support it on jackstands. Proceed by removing the wheel, followed by the three upper shock absorber mounting nuts and the lower shock absorber mounting nut and bolt. You'll also need to remove the brake caliper and disc. Additionally, detach the wheel speed sensor from the steering knuckle and upper control arm, detach the upper balljoint from the steering knuckle, and detach the stabilizer link from the lower control arm. Finally, remove the driveaxle/hub nut and pull the top of the knuckle out to remove the shock absorber/coil spring assembly.

Start by raising the rear of the vehicle and supporting it securely on jackstands placed under the frame rails. Support the rear axle with a floor jack placed under the axle tube on the side being worked on.

Clean the lower end of the steering knuckle and have an assistant grasp the lower edge of the tire and move the wheel in-and-out while checking for movement at the steering knuckle-to-control arm ball joint. If there is any movement, the suspension ball joint(s) must be replaced.

For 4WD models with a solid front axle, you'll need to remove the shock absorber upper mounting bracket in addition to the other steps. This bracket removal is part of the process.

Remove the nut and bolt that attach the upper end of the shock absorber to the frame, and if necessary, apply penetrating oil to loosen any rust. Then, remove the nut and bolt that attach the lower end of the shock to the axle bracket, again using penetrating oil if needed.