Mopar 68170199AB ABSORBER Pkg-Suspension

You can Select Your Vehicle to check if 68170199AB fits your vehicle.

Extend the new shock absorber as far as possible and install new rubber grommets into the shock absorber eyes. Finally, install the new shock absorber by reversing the removal process and tightening the shock absorber mounting fasteners.

Certainly. For 4WD models with a solid front axle, start by loosening the driveaxle/hub nut and wheel lug nuts on 1500 4WD models. Then, raise the front of the vehicle and securely support it on jackstands. Proceed by removing the wheel, followed by the three upper shock absorber mounting nuts and the lower shock absorber mounting nut and bolt. You'll also need to remove the brake caliper and disc. Additionally, detach the wheel speed sensor from the steering knuckle and upper control arm, detach the upper balljoint from the steering knuckle, and detach the stabilizer link from the lower control arm. Finally, remove the driveaxle/hub nut and pull the top of the knuckle out to remove the shock absorber/coil spring assembly.

If leakage is noted in the shock absorbers, replace them as a set. A light film of fluid is no cause for concern, but significant leakage should be addressed.