Mopar 5086599AG ABSBRPKG-Suspension

You can Select Your Vehicle to check if 5086599AG fits your vehicle.

Loosen wheel lug nuts and driveaxle/hub nut. Support lower control arm with floor jack. Remove upper mounting nut and retainer/grommet. Remove lower mounting nuts and pull shock out. Apply thread locking compound to stud before installing upper mounting nut. For 4WD models, remove upper mounting bracket and lower mounting bolt. Raise vehicle, support securely, and remove wheel. Remove three upper mounting nuts and lower mounting nut/bolt. Detach wheel speed sensor, upper balljoint, and stabilizer link. Remove driveaxle/hub nut and pull knuckle out to remove shock absorber/coil spring assembly. Installation is reverse of removal, ensuring all fasteners are tightened.

Remove the nut and bolt that attach the upper end of the shock absorber to the frame, and if necessary, apply penetrating oil to loosen any rust. Then, remove the nut and bolt that attach the lower end of the shock to the axle bracket, again using penetrating oil if needed.

If leakage is noted in the shock absorbers, replace them as a set. A light film of fluid is no cause for concern, but significant leakage should be addressed.