Mopar 5105115AA ABSORBER-Suspension

You can Select Your Vehicle to check if 5105115AA fits your vehicle.

Inspect the strut body for leaking fluid, dents, damage and corrosion. Check the spring for nicks, chips or cracks in the spring coating.

Raise the vehicle and secure it on jack stands. Examine the shock absorbers/struts for evidence of fluid leakage. Ensure that they are securely mounted and free from damage. Check the upper mounts for any signs of damage or wear. If leakage or damage is detected, it's recommended to replace the shocks/struts as a set.

Extend the damper rod and install the rubber bumper. Position the coil spring with the smaller coils going on first and carefully place it onto the damper shaft. Install the rubber bumper and push it all the way down. Install the upper spring seat and dust boot onto the damper shaft. Install the suspension support, aligning the support notch with the clevis bracket on the strut support. Install the nut and tighten it to the specified torque. Loosen the coil spring compressor(s) until the top coil is properly seated against the upper spring seat and suspension support. Relieve all tension from the spring compressor(s) and remove them from the coil spring. Finally, install the strut/spring assembly.

Raise the rear of the vehicle and securely support it on jackstands placed underneath the rear jacking points.