Mopar 52106577AB Upper Control Arm

You can Select Your Vehicle to check if 52106577AB fits your vehicle.

To remove the wheel, start by loosening the lug nuts and raising the vehicle securely on jackstands. Then, loosen the nut on the upper balljoint stud and disconnect the balljoint from the steering knuckle using a balljoint removal tool. If you don't have the proper tool, a picklefork type separator can be used, but it may damage the balljoint boot. Next, remove the control arm mounting fasteners and pull the upper arm from its frame brackets. To install, reverse the removal steps and tighten all fasteners to the specified torque values. However, don't tighten the pivot bolt nuts until the vehicle is at normal ride height. If necessary, simulate normal ride height by raising the outer end of the lower control arm with a floor jack. Finally, install the wheel, lower the vehicle, and tighten the lug nuts. Remember to have the front end alignment checked and adjusted if needed.

Remove the parking brake cable bracket (left arm only) and the control arm fasteners at the axle and at the frame. Remove the lower control arm. Inspect all rubber bushings for wear and damage, replacing any that are cracked, torn, or deteriorated.

Remove the brake disc and disconnect the wheel speed sensor.