Mopar 4721419AE Bar-Front

You can Select Your Vehicle to check if 4721419AE fits your vehicle.

The vehicle should be raised after the lug nuts have been loosened on both front wheels, and then they can be removed. The control arms need to be separated from the sway bar kit by removing the nuts, bolts, and retainers that hold them. The sway bar kit can only be taken out by pulling apart the two clamps bolted to the cross member. You may inspect damage on the bar, bushings, clamps, or retainers. Open pry inner bushings out of their position to remove them. Orient new production bushings with the curved side up. To remove outer bushings, chop them off with a hammer or cut through them. Until One-half inch juts over, install freshly made bushing onto the last end of a rod; use silicone spray lubricant for this process. Then loosely put in place clamps as well as bolts together with nuts into position to attach it to a cross-member.