Mopar 5183454AA Battery-Flashlight

You can Select Your Vehicle to check if 5183454AA fits your vehicle.

Before disconnecting the battery, remove the key from the ignition and keep it with you. Alternatively, use a memory-saver device plugged into the cigarette lighter and connected to a spare battery. To disconnect the battery, loosen the cable clamp nut and disconnect the cable from the negative terminal, isolating the cable end.

Install a memory saver device to avoid reprogramming several of the vehicle's systems. Remove the air filter housing fresh air duct by rotating the retaining clips and taking out the duct. Disconnect the negative battery cable, followed by the positive cable, from the battery. Unscrew the bolt and remove the hold-down clamp from the bottom edge of the battery. Lift out the battery using special battery removal tools available at auto parts stores for easier handling. Installation involves connecting the positive cable first, followed by the negative cable. If equipped, transfer the battery insulator to the new battery when replacing. For the battery tray, remove the battery, followed by the tray liner if one exists. Finally, remove the battery tray fasteners and lift the tray out. Installation follows the reverse order of removal.

Start by removing the battery hold-down clamp. Unscrew the hold-down bolt and remove the clamp. Carefully lift out the heavy battery.

Look at the indicator eye on the top of the battery (if equipped). A green indicator eye means the battery is 75 to 100 percent charged, black indicates 0 to 75 percent charged, and clear or bright indicates low electrolyte level. Maintenance-free batteries with clear indicator eyes should be replaced, while low-maintenance batteries with removable cell caps can have distilled water added to the correct level. Perform an open-voltage circuit test using a voltmeter to check the battery voltage, ensuring the surface charge is removed for accurate measurement. A fully charged battery should have at least 12.4 volts. Charge the battery if the voltage is lower. Perform a battery load test with a battery load tester to assess the battery's ability to handle heavy amperage draw. A fully functional battery should not drop below 9.6 volts during the test.