Mopar 4868999AB Battery-Storage

You can Select Your Vehicle to check if 4868999AB fits your vehicle.

Some systems on the vehicle require battery power to be available at all times, either to maintain continuous operation or to maintain control unit memory. When the battery is disconnected, the power that maintains these systems is cut. It is a wise precaution to remove the key from the ignition and keep it with you before disconnecting the battery, especially on a vehicle with power door locks, to prevent the key from getting locked inside if the power door locks engage accidentally when the battery is reconnected. To avoid these problems, memory-savers can be used. These devices, typically plugged into the cigarette lighter and connected to a spare battery, provide sufficient current to maintain audio unit security codes, PCM memory, and power to always hot circuits such as the clock and radio memory circuits. The battery location and disconnection process differ between 2014 and earlier models and 2015 and later models. In 2014 and earlier models, the battery is mounted behind the lower front portion of the left front fender, and the remote positive and negative terminals are located in the engine compartment at the left strut tower. To disconnect the battery, loosen the cable end nut of the remote negative terminal, disconnect the cable from the remote ground terminal, attach the plastic insulator portion of the cable to the stud, and reinstall the nut. In 2015 and later models, the battery is located in the engine compartment, and the battery cables are accessible after opening the hood. To disconnect the battery, first disconnect the Intelligent Battery Sensor (IBS) electrical connector from the negative cable (if equipped), then loosen the negative battery cable clamp nut, lift the cable off the negative terminal, and secure it aside to prevent accidental reconnection. It is important to note that whenever the battery is disconnected on 2015 and later models, the Intelligent Battery Sensor (IBS) electrical connector must be disconnected prior to disconnecting the negative cable from the battery post.

Slow-rate charging with a one or two-amp trickle charger is best for restoring discharged batteries and maintaining charge during short drives.

It cautions against rapid boost charges that can damage the battery.

The battery is located in the engine compartment, and the battery cables are accessible after opening the hood.

Precautions include turning off the engine and accessories, disconnecting the negative battery terminal, avoiding sparks, flames, or smoking near the battery, and charging it in a well-ventilated area. Eye protection and gloves are also essential.

Cold temperatures may require adjustments to the minimum voltage.

Disconnect and isolate the remote battery cable. Loosen the left front wheel lug nuts, raise the front of the vehicle and support it securely on jackstands, then remove the wheel. Remove the push pins and the inner-fender splash shield from the left front wheel well. Remove and isolate the negative battery cable before doing the same to the positive battery cable. Remove the battery retaining bracket nut, then remove the bracket and the battery from the wheel well. Be careful.

Loosen the left-front wheel lug nuts, then raise the front of the vehicle and support it on jackstands. Remove the left-front wheel and inner fender splash shield. Also remove the engine under cover. Remove the fuse box assembly mounting bolts and position it to the side. Remove the Powertrain Control Module (PCM) mounting bolts, then position it to the side. If necessary, also remove the PCM mount for better access. Detach any wiring harness clips from the battery tray, then remove the battery tray mounting bolts - accessed by working from the engine compartment, fenderwell, and from below the vehicle. Remove the battery tray, rotating it as necessary. Installation is the reverse of removal.

Some systems on the vehicle require battery power to be available at all times, either to maintain continuous operation or to maintain control unit memory.

Unscrew the bolt and remove the hold-down clamp from the bottom edge of the battery. Lift out the battery using special battery removal tools available at auto parts stores for easier handling.

Disconnect the negative battery cable first, followed by the positive cable, to avoid shorting the battery.