Mopar BA86F540AA Battery-Storage

You can Select Your Vehicle to check if BA86F540AA fits your vehicle.

If corrosion is present, the battery should be removed for cleaning. The ground cable should be removed first. Cable clamps, terminals, and the battery top should be cleaned with a baking soda solution, taking precautions to protect your eyes and hands.

To disconnect the battery, first disconnect the Intelligent Battery Sensor (IBS) electrical connector from the negative cable (if equipped), then loosen the negative battery cable clamp nut, lift the cable off the negative terminal, and secure it aside to prevent accidental reconnection. It is important to note that whenever the battery is disconnected on 2015 and later models, the Intelligent Battery Sensor (IBS) electrical connector must be disconnected prior to disconnecting the negative cable from the battery post.

Disconnect and isolate the remote battery cable. Loosen the left front wheel lug nuts, raise the front of the vehicle and support it securely on jackstands, then remove the wheel. Remove the push pins and the inner-fender splash shield from the left front wheel well. Remove and isolate the negative battery cable before doing the same to the positive battery cable. Remove the battery retaining bracket nut, then remove the bracket and the battery from the wheel well. Be careful.

Loosen the left-front wheel lug nuts, then raise the front of the vehicle and support it on jackstands. Remove the left-front wheel and inner fender splash shield. Also remove the engine under cover. Remove the fuse box assembly mounting bolts and position it to the side. Remove the Powertrain Control Module (PCM) mounting bolts, then position it to the side. If necessary, also remove the PCM mount for better access. Detach any wiring harness clips from the battery tray, then remove the battery tray mounting bolts - accessed by working from the engine compartment, fenderwell, and from below the vehicle. Remove the battery tray, rotating it as necessary. Installation is the reverse of removal.

The battery is located in the engine compartment, and the battery cables are accessible after opening the hood.

Routine battery maintenance is crucial for these vehicles to ensure reliable starts.