Mopar 4721515AC Brake Hub And Bearing

You can Select Your Vehicle to check if 4721515AC fits your vehicle.

Start by loosening the drive axle/hub nut and wheel lug nuts. Raise the vehicle, and remove the wheel, brake caliper, bracket, and disc. Remove the hub/bearing assembly. For installation, ensure the mounting surface inside the knuckle and on the drive axle splines is smooth. Install the drive axle/hub nut, brake disc, bracket, and caliper. Install the wheel and lug nuts, and tighten the drive axle/hub nut and lug nuts.

Tighten the lug nuts.

Tighten the lug nuts.

Start by loosening the driveaxle/hub nut and the wheel lug nuts. Then, raise the vehicle and remove the wheel. Next, remove the brake caliper, caliper mounting bracket, and brake disc. Remove the driveaxle/hub nut and the hub/bearing assembly mounting bolts from the rear of the steering knuckle. Finally, remove the hub/bearing assembly from the steering knuckle.

Carefully position the drum/hub assembly on the spindle to insert the grease-packed outer bearing. Install the washer and nut, tightening it slightly (up to 12 ft-lbs of torque). Spin the drum/hub forward to seat the bearings, then recheck the nut's tightness (approximately 12 ft-lbs). Loosen the nut until it's just loose, then snug it up by hand. Secure it with a new cotter pin and lock, bending the cotter pin ends flat against the nut. Install the grease cap with a hammer, place the wheel, and tighten the lug nuts securely. Check the bearings' condition by grasping the tire's top and bottom. Finally, lower the vehicle and retighten the lug nuts to complete the procedure.

Continue by removing the stabilizer bar retainer bolts and the retainer washer (if equipped) from the wheel stud. Remove the brake disc. Mark the position of the camber cam. Remove the balljoint pinch bolt and nut, as well as the steering knuckle-to-strut bolts and nuts.