Mopar 4721762AH Brake Bearing

You can Select Your Vehicle to check if 4721762AH fits your vehicle.

In the straight-ahead position, grasp the knuckle and hub assembly, pulling it directly out and off the driveaxle splines, taking care not to disengage the inner CV joint. For inspection, place the assembly on a clean work surface, wipe it clean, and check the knuckle for rust, damage, and cracks. Ensure the bearings rotate freely without excessive noise or looseness and are adequately greased. Disassembly beyond this point may require specialized tools if there are issues with the bearings.

Carefully position the drum/hub assembly on the spindle to insert the grease-packed outer bearing. Install the washer and nut, tightening it slightly (up to 12 ft-lbs of torque). Spin the drum/hub forward to seat the bearings, then recheck the nut's tightness (approximately 12 ft-lbs). Loosen the nut until it's just loose, then snug it up by hand. Secure it with a new cotter pin and lock, bending the cotter pin ends flat against the nut. Install the grease cap with a hammer, place the wheel, and tighten the lug nuts securely. Check the bearings' condition by grasping the tire's top and bottom. Finally, lower the vehicle and retighten the lug nuts to complete the procedure.