Mopar 4505907 Boot Pkg Shaft Inner Cv

You can Select Your Vehicle to check if 4505907 fits your vehicle.

First of all, if a boot is damaged or leaking, replace it promptly to avoid CV joint damage. Remove the drive axle and disassemble the CV joint to access the CV Boot. Inspect the CV joint for contamination or inadequate lubrication. Clean the old grease from the CV joint and repack it with the kit's grease. Pack the new CV Boot with the remaining grease. For soft rubber CV Boots, slide the smaller end of the boot over the shaft and secure it with clamping straps. For hard plastic CV Boots, slide the boot onto the shaft, align it with the third locating groove, and secure it with a clamp. Install the CV joint and secure the large CV Boot end with a clamp.

Serious and costly damage can occur to the CV joints that the boots are designed to protect.

Before commencing the boot replacement procedure, secure a replacement boot kit appropriate for your specific application. Various boot types may require distinct replacement methods. Additionally, begin by removing the driveaxle and disassembling the CV joint to access the boot.

Raise the front of the vehicle and support it securely on jackstands. Crawl under the vehicle and check the four driveaxle boots (two on each driveaxle) very carefully for cracks, tears, holes, deteriorated rubber, and loose or missing clamps.