Mopar 68137446AA Bracket-Engine Mount

You can Select Your Vehicle to check if 68137446AA fits your vehicle.

Because engine mounts are generally unobtrusive, it is very important that damaged or decayed mounts are instantly replaced to avoid further strain on the drive line parts. As a part of inspection, the weight from the mounts must be slightly lifted by raising the engine. To check this; raise the vehicle and support secure it on jackstands then place a wooden block between the jack head and oil pan under the engine oil pan to lift it up slightly. Check for any movement between inner and outer parts of mountings and if there is any movement then lower down engine and tighten mounting fasteners. Secondly, inspect for cracks in rubber from metal casing, hardening of rubber or separation of rubber from metal casing, which all shows that they should be replaced. For replacement: first disconnect battery cable, remove fanshroud attaching bolts to shroud attachement brackets, remove the engine cooling fan, and raise the front of the vehicle on jackstands. The motor will have to be supported from above with an appropriate lifting device taking care not to engage it with manifold intake so as to raise such motor in order to bring about release of mount's weight. Follow these steps depending on whether your model is 2WD or 4WD: Remove engine heat shield (if equipped). Lowering frame bracket free-bolt guide-engine support assembly into position on through bolt plate . Reverse procedure to complete installation .Finally, remove the engine hoist and jackstands, and lower the vehicle.

Yes, rubber preservative may be applied to the mounts to slow down deterioration.

By raising the vehicle and supporting it securely on jackstands. Then, positioning a jack under the engine oil pan and raising the engine slightly to remove the weight from the mounts.

If any movement is observed between the inner and outer portions of the mounts, lower the engine and tighten the mount fasteners.

If the engine mounts are broken or deteriorated, they should be replaced immediately to prevent damage or accelerated wear on drive line components.

By raising the vehicle and supporting it securely on jackstands. Then, positioning a jack under the engine oil pan and raising the engine slightly to remove the weight from the mounts.