Mopar 4861640AA Cable-Throttle Control

You can Select Your Vehicle to check if 4861640AA fits your vehicle.

Start by rotating the throttle linkage cam to the wide-open position and disengaging the accelerator cable from the slot in the throttle lever cam. Squeeze the retaining ears together and disengage the accelerator cable from the cable bracket. Reach up behind the accelerator pedal and disengage the retainer from the top of the accelerator pedal. Remove the horseshoe-shaped retainer clip that retains the cable grommet to its hole in the firewall and work the cable grommet out of the hole. Finally, pull out the cable from the engine compartment side of the firewall.

Start by rotating the throttle linkage cam to the wide-open position and disengaging the accelerator cable from the slot in the throttle lever cam. Squeeze the retaining ears together and disengage the accelerator cable from the cable bracket. Reach up behind the accelerator pedal and disengage the retainer from the top of the accelerator pedal. Remove the horseshoe-shaped retainer clip that retains the cable grommet to its hole in the firewall and work the cable grommet out of the hole. Finally, pull out the cable from the engine compartment side of the firewall.

For rod adjustment, loosen the adjustment swivel lock screw and ensure the swivel slides freely along the flat end of the throttle rod; if it does not, disassemble the linkage for cleaning or repair.

Disconnect the accelerator cable from the pedal shaft inside the vehicle and disconnect it from the firewall. In the engine compartment, pull the cable housing end fitting out of the dash panel grommet, ensuring the grommet remains in place. Remove the retainer and disconnect the accelerator cable and cruise control cable (if equipped) from the throttle body. Use pliers to compress the end fitting tabs and separate the cable from the mounting bracket.