Mopar 4861742AD Cable-Throttle Control

You can Select Your Vehicle to check if 4861742AD fits your vehicle.

The installation process is the reverse of the removal steps.

Start by rotating the throttle linkage cam to the wide-open position and disengaging the accelerator cable from the slot in the throttle lever cam. Squeeze the retaining ears together and disengage the accelerator cable from the cable bracket. Reach up behind the accelerator pedal and disengage the retainer from the top of the accelerator pedal. Remove the horseshoe-shaped retainer clip that retains the cable grommet to its hole in the firewall and work the cable grommet out of the hole. Finally, pull out the cable from the engine compartment side of the firewall.

For rod adjustment, loosen the adjustment swivel lock screw and ensure the swivel slides freely along the flat end of the throttle rod; if it does not, disassemble the linkage for cleaning or repair.

Start by removing the retainer or plug inside the vehicle and detach the cable end from the accelerator pedal shaft. Then, remove the retainer clip from the cable assembly housing at the grommet and pull the cable through the firewall. In the engine compartment, remove the retainer clip and separate the cable from the pin or stud on the throttle lever using needle-nose pliers. Detach the cable from the mounting bracket by compressing the cable-to-bracket fitting with pliers and pulling the cable through the bracket.