Mopar 68210518AA Engine Camshaft

You can Select Your Vehicle to check if 68210518AA fits your vehicle.

With the tappets secured, remove the camshaft thrust plate bolts, carefully pull out the camshaft, and retrieve the tappets using a special tool. After removal, inspect the camshaft and tappets for wear, damage, and measurements. Replace components as needed.

The first step is to disconnect the cable from the negative terminal of the battery.

A new camshaft must also be installed.

To begin the installation process, dip the hydraulic lash adjusters in clean engine oil and install them in their original locations. Apply grease or engine assembly lube to the rocker arm contact points and rollers and install them in their original locations. Lubricate the camshaft bearing journals and lobes and carefully install the camshafts in the cylinder head. Install the camshaft bearing caps and tighten them to the specified torque. Rotate the camshafts and verify the alignment holes are in the neutral position. Slide the intake and exhaust phasers onto the camshafts and ensure the marks are aligned. Install the oil control valves into the camshaft phasers and tighten them to the specified torque. Release the tensioner plunger and rotate the engine to verify the alignment marks.