Mopar 2AMR2311AA Engine Cooling Radiator

You can Select Your Vehicle to check if 2AMR2311AA fits your vehicle.

Set the parking brake, raise the front of the vehicle and support it securely on jackstands. Drain the cooling system. If the coolant is relatively new and in good condition, save it and reuse it. Remove the engine cooling fans. Detach the coolant reservoir hose from the radiator filler neck and retainer and then move it aside. Remove the vapor purge solenoid from its mounting bracket. Remove the lower engine splash shield. Disconnect the upper and lower radiator hoses. Carefully separate the NC condenser from the radiator by removing the fasteners and then pulling the condenser up to release the lower clips.

Set the parking brake, raise the front of the vehicle and support it securely on jackstands. Drain the cooling system. If the coolant is relatively new and in good condition, save it and reuse it. Remove the engine cooling fans. Detach the coolant reservoir hose from the radiator filler neck and retainer and then move it aside. Remove the vapor purge solenoid from its mounting bracket. Remove the lower engine splash shield. Disconnect the upper and lower radiator hoses. Carefully separate the NC condenser from the radiator by removing the fasteners and then pulling the condenser up to release the lower clips.

Inspect the radiator mounts for deterioration and ensure they are free from dirt or gravel. Install the radiator by properly seating it on the lower mounting insulators before fastening the top brackets. Fill the cooling system with the proper mixture of antifreeze and water. Start the engine and check for leaks. Allow the engine to reach normal operating temperature. Recheck the coolant level and add more if necessary. If working on an automatic transaxle equipped vehicle, check and add fluid as needed.